Table of Contents
Advertisement
Installation
Post Installation
The average installation will require approximately 180 degrees
of rotation as shown.
1. Loosen set screws
[Figure 20-3 ]
2. Plug in the hand control and turn the lift 'On.'
Press the 'In /Out' button to test the post height.
[Figure 20-4]
Ideally, the post's horizontal tubing should just
clear the truck's bed side wall. Adjust height as
required.
20
SECTION 2 : INSTALLER
[Figures 20-1 & 20-2]
Figure 20-1
and insert vertical post.
| www.harmar.com | 800-833-0478
180
Figure 20-2
3/8-16
2" Increments
Nyloc Nut
Figure 20-3
M IN IM A L
Figure 20-4
3/8-16 x 3-1/2"L
Loosen
Hex Head Cap Screw
Set Screws
(x4)
1" Fine Tuning
Increment
Adjust set screws until
post is vertically level.
Advertisement
Table of Contents
