Table of Contents
Advertisement
Installation
SECTION 2 : INSTALLER
Base Installation
Driver's Side Base
1. Place base in corner of truck bed
as shown. Attempt to position as close
to the corner as possible. Leave at least
OR
1" around on all sides. [Figure 16-1]
Passenger's Side Base
( sold as option )
[Figure 16-1]
2. Install leg extensions
into base tubes as far as
they will go. Set screws can be hand-tightened at this
time. [Figure 16-2]
[Figure 16-2]
3. Plan drilling.
Three 3/8" holes will need to be
drilled through the truck bed and, when possible,
through the frame of the truck in the down
locations. [Figure 16-3]
Two more 3/8" holes will need to be drilled through
the truck bed if frame is not captured, bed material is
too thin, and/or application is very heavy.
[Figure 16-3]
16
| www.harmar.com | 800-833-0478
Advertisement
Table of Contents
