Table of Contents
Advertisement
Installation
SECTION 2 : INSTALLER
3. Open the enclosure and insert the wires through
the grommet.
Pull enough wire through to be able
to manipulate the ends. (Save screws to seal the
enclosure at the end.) [Figure 25-1]
SAVE FOR
STEP #4
4. Pull off the individually pre-stripped insulation
Figure 25-1
ends.
Twist each end of the wires individually to keep
all the wire strands together.[Figure 25-2
Figure 25-2
]5. Insert each color wire into their appropriately-
labeled terminal.
Tighten each wire down after
insertion. [Figure 25-3]
Test each wire by pulling it moderately to make sure
that it is secure in the contact block.
Figure 25-3
AL815CC, AL825, AL825CC, AL835 Hybrid Installation & Owner's Manual 2017
25
TEC00037
2016FEB20
P/N: 630-00053 Rev A
Advertisement
Table of Contents
