Harmar Mobility AL815CC Installation & Owner's Manual page 19

Wherever possible incorporate the frame rails of the
truck. This is a requirement when lifting heavier chairs
and scooters. [Figure 19-1]
Figure 19-1
As a last resort, if the truck frame cannot be used in
the mounting, adding these two anchor brackets will
help stabilize the lift and help prevent the truck bed
from tearing. [Figure 19-2]
Anchor
Bracket
Installation
Washer
3/8 Split
Loc Washer
3/8-16
Hex nut
Figure 19-2
TEC00037 2016FEB20 P/N: 630-00053 Rev A
SECTION 2 : INSTALLER
F R A M E
F R
A
M
E
3/8-16 x 3.50
Hex Head
Cap Screw
3/8-16 x 3.50
Hex Head
Cap Screw
Anchor
Bracket
Installation
Washer
3/8-16
Hex nut
AL815CC, AL825, AL825CC, AL835 Hybrid Installation & Owner's Manual 2017
Installation
5. Remove temporary hex nut.
Assembly as shown. Tighten bolts to approx. 30 ft. lbs.
Remove
3/8-16
HEX NUT
Temporary
Figure 19-3
6. Finish assembly
with one more loc washer and hex
nut in corner as shown. Tighten to approx. 30 ft. lbs.
Cut off excess all thread if desired.
3/8-16
Hex Nut
3/8 Split
Loc Washer
Figure 19-4
Attach Power Base
3/8-16 x 2-3/4"L
Socket Head
Cap Screw (x3)
3/8 Split
Loc Washer
(x3)
19