Repeat The Last Instrument Run; Edit An Experiment Before Starting A Run; Enter Or Edit Template Properties - Thermo Scientific QuantStudio 1 Installation, Use And Maintenance Manual

Repeat the last
instrument run

Edit an experiment before starting a run

Enter or edit
template
properties
QuantStudio 1 Real-Time PCR System Installation, Use, and Maintenance Guide
™
7. (Optional) Define plate wells with sample names and view Well ID, Targets, or
Dyes (see "Define, assign, and view well details").
8. Load a plate into the instrument (see "Load and unload a plate in the
QuantStudio 1 Real-Time PCR Instrument" on page 22).
™
9. Touch Start Run.
When prompted, confirm that you inserted a plate.
Note: To disable this reminder, select Do not show again or select
Settings4Insert Plate Reminder in the home screen.
This feature applies only to runs started from the instrument and is not available for
runs started from the desktop software. If you are signed-in, this feature applies to the
last run from your instrument profile.
1. In the home screen, touch
2. (Optional) Enter or edit template properties, including Run File Name (EDS file
name), Plate Barcode, Reagent Information, and Data Destination (see "Enter
or edit template properties").
3. (Optional) Edit the run method (see "Edit the run method" on page 43).
• Add, remove, or edit a step, stage, melt curve, or data collection point.
• Adjust the heated cover temperature, sample volume, or number of cycles.
• Configure ramp rate and pause settings.
4. (Optional) Define plate wells with sample names and view Well ID, Targets, or
Dyes (see "Define, assign, and view well details").
5. Load a plate into the instrument (see "Load and unload a plate in the
QuantStudio 1 Real-Time PCR Instrument" on page 22).
™
6. Touch Start Run.
When prompted, confirm that you inserted a plate.
Note: To disable this reminder, select Do not show again or select
Settings4Insert Plate Reminder in the home screen.
Access a template (EDT file). For more information, see the following sections.
• "Create and run an experiment from a template" on page 40.
• "Run an experiment from a saved file" on page 40.
• "Repeat the last instrument run" on page 41.
In the Properties screen, touch Edit to enter or edit template properties.
• Edit the file name for the EDS file for the run.
a. Touch the Run File Name field.
Chapter 4 Create and run experiments on the instrument

Edit an experiment before starting a run

Run Last.
4
41