AEMC DTR 8510 User Manual page 21

3. The display will now show the following screen:
4. Select List by pressing the ▼ key. The list can then be scrolled from
0 to 9 Nameplate values by using the ▼ or ▲ key. Select the desired
Nameplate by pressing ENTER. The display will return to Setup
Nameplate.
5. Press ENTER, then Yes (▼) on Enable.
6. Select Edit by pressing the ▼ key. The values in the Present Name-
plate can be edited digit by digit by selecting each digit with the ▼ or
▲ and then pressing the ENTER key. When the last digit on the Sec-
ondary is selected, the display returns to Setup Nameplate.
NOTE:
• Selecting one transformer from the list will replace the values
in the Present Nameplate immediately. The values can then be
changed in the Edit mode if needed.
• Selecting Edit will allow the user to modify the values in the
Present Nameplate.
• The Edit process changes the values in the Present Nameplate
only. The values previously stored would remain the same. The
stored List values can only be changed in DataView
Digital Transformer Ratiometer DTR
Shop for AEMC products online at:
Figure 4-11
Figure 4-12
Figure 4-13
Model 8510
®
ShopAEMC
www.
.
®
.com 1.877.766.5412
19