Install The Module - Rockwell Automation Series C Installation Instructions Manual

Install the Module

The module can be installed before or after base installation. Make sure that the mounting
base is correctly keyed before installing the module into the mounting base. In addition,
make sure the mounting base locking screw is positioned horizontal referenced to the base.
WARNING: When you insert or remove the module while backplane power is
on, an electrical arc can occur. This could cause an explosion in hazardous
location installations.
Be sure that power is removed or the area is nonhazardous before proceeding.
Repeated electrical arcing causes excessive wear to contacts on both the
module and its mating connector. Worn contacts may create electrical
resistance that can affect module operation.
1734-TB base
Turn the keyswitch to align the
number with the notch.
Notch position 3 is shown here.
Make sure the DIN-rail locking
screw is in the horizontal position.
POINT I/O 120V AC Input Module
Publication 1734-IN010E-EN-E - August 2016
9
45696