Overview
Before You Install
Your Module
Power Requirements
13
Install Your FLEX I/O Frequency Input Module
This chapter provides you with pre-installation requirements and instructions
on how to install your FLEX I/O Frequency Input modules.
Topic
Before You Install Your Module
Power Requirements
Install the Module
Mount on a DIN Rail
Mount on a Panel or Wall
Mount the Frequency Input Module on the Terminal Base Unit
Wiring Information
Connect Wiring to the FLEX I/O Frequency Input Module
Connecting Wiring Using a 1794-TB3G, 1794-TB3GK or 1794-TB3GS
Terminal Base Unit
Resolution and Accuracy
Examples of Wiring to a 1794-TB3G Terminal Base Unit
Chapter Summary
Before installing your frequency input module in the FLEX I/O system, you
need to:
• calculate the power requirements of all modules in each FLEX I/O
system, and
• position the keyswitch on the terminal base.
This FLEX I/O module does not receive primary operational power
ATTENTION
from the backplane. 24V DC power must be applied to your module
before installation. If power is not applied, the module position may
appear to the adapter as an empty slot in your chassis.
The wiring of the terminal base unit is determined by the current draw
through the terminal base. Make certain that the current draw does not
exceed 10 A.
Chapter
Page
13
13
14
14
16
18
20
21
22
24
27
27
Publication 1794-6.5.11 - September 2011
2