Replacing the status-light board
WARNING: Before working inside your computer, read the safety information that shipped with your computer and
follow the steps in
instructions in
After Working Inside Your
home page at dell.com/regulatory_compliance.
Procedure
1
Slide the status-light board cable into the status-light board connector and press down the latch to secure the cable.
2
Align the screw hole on the status-light board with the screw hole on the palm-rest assembly.
3
Replace the screw that secures the status-light board to the palm-rest assembly.
Post-requisites
1
Follow the procedure from step 3 to step 4 in "Replacing the keyboard".
2
Follow the procedure from step 5 to step 9 in "Replacing the
3
Follow the procedure from step 3 to step 7 in "Replacing the
4
Replace the
base
panel.
38
Before Working Inside Your
Computer. For more safety best practices, see the Regulatory Compliance
Computer. After working inside your computer, follow the
palm
rest".
solid-state
drive" .