Selecting Cables; Bringing Cables Into The Auxiliary Terminal Box And Routing Them - Siemens SIMOTICS HV C Operating And Installation Instructions

Induction motor

Table of Contents

6.4.2

Selecting cables

Take the following criteria into account when selecting the connecting cables for the auxiliary

circuits:

● Rated current

● Rated voltage

● System-dependent conditions, such as ambient temperature, routing type, cable cross-

● Requirements according to IEC/EN 60204‑1

● Requirements according to IEC/EN 60079‑14

6.4.3

The type designations of the mounted auxiliary terminal boxes, their arrangement, and the

relevant connection terminals are documented in the "Technical data and drawings" section.

The information required to connect the auxiliary circuits is provided in the terminal diagram

located on the inside of the terminal box cover and in the "Technical specifications" section.

The connectable cable cross-sections and the dimensions are listed in "Technical Data".

Adapting the cable glands

A plate is bolted to the terminal box enclosure via a rectangular cutout through which the

connecting cables enter. Normally, this plate is supplied without threaded holes for the cable

glands. This enables you to adapt the number and size of the cable glands to the rated

conditions.

Degree of protection

Use only cable glands that are suitable for the degree of protection of the auxiliary terminal

box.

Introducing and routing the cables

1. Open the auxiliary terminal box and undo the cable entry plate screws.

2. Drill the required number of holes or threads in the required size of the cable gland into the

3. Mark the cables if necessary for subsequent assignment.

4. Pull the cables through the cable glands and the entry plate, and connect the cables.

5. Fit the cable entry plate.

6. Make sure that the seal on the screwed sockets for the cable glands satisfies the degree

Table of Contents

1nb1402-2aa84-4ca0-z