Safety Information; Information For Those Responsible For The Plant - Siemens SIMOTICS HV C Operating And Installation Instructions

Safety information

2.1

Information for those responsible for the plant

This machine has been designed for use in industrial plants in accordance with Directive
2006/42/EC ("Machinery Directive"). Commissioning in the European Community is forbidden
until the plant into which the machine will be installed has been shown to conform with this
directive. Please observe the country-specific regulations when using the machine outside the
European Community.
Follow the local and industry-specific safety and setup regulations.
The persons responsible for the plant must ensure the following:
● Planning and configuration work and all work carried out on and with the machine is only
● The operating instructions must always be available for all work.
● The technical data as well as the permissible installation, connection and operating
● The specific setup and safety regulations as well as regulations on the use of personal
In the individual chapters of this document, you will find warning and safety instructions that
must be observed without fail, for your own safety, to protect other people and to avoid material
damage.
Observe the following safety instructions for all activities on and with the machine.
This machine has been designed and built in accordance with Directives GB 3836.1
("Explosive atmospheres – Equipment – General requirements") and GB 3836.2 ("Equipment
protection by flameproof enclosures "d""), and is designed for use in hazardous zones in
industrial plants and systems.
Commissioning in the European Community in accordance with directive 2006/42/EU
("Machine Directive") is forbidden until the plant into which the machine will be installed has
been shown to conform with this directive. Please observe the country-specific regulations
when using the machine outside the European Community.
Risk of explosion with commissioning prior to determining the conformity
If the machine is commissioned prior to determining the plant conformance, the explosion
protection of the plant is not guaranteed. An explosion can result that can lead to death, serious
injury or material damage.
● Only commission the machine if it has been absolutely confirmed that the plant or system
SIMOTICS HV C 1NB1402-2AA84-4CA0-Z
Operating Instructions 06/2018
to be done by qualified personnel.
conditions are always consequentially taken into account.
protective equipment are observed.
Note
Use the services and support provided by the local Service Center (Page 111) for planning,
installation, commissioning and service work.
is in full conformance with the valid directive.
2
13