Protection Against Corrosion; Converter Operation; Tandem Operation - Siemens SIMOTICS HV C Operating And Installation Instructions

Preparations for use

4.14 Converter operation

4.13.11

Protection against corrosion

If the machine is stored in dry conditions, then apply the subsequently listed anti-corrosion
measures:
● Storage up to six months:
● Storage for longer than six months:
● Inspect the machine regularly and if necessary, apply an additional coating of corrosion
Document all preservation measures taken so that they can be reversed before the machines
are put back into service.
4.14 Converter operation
4.14.1

Tandem operation

If you connect two motors in series for "tandem operation", install an insulated coupling
between the motors; this coupling should satisfy series of standards GB 25286 or the
regulations that apply in the country where the equipment is installed.
38
Apply a coat of corrosion protective compound to all accessible bare metal parts such as
the exposed shaft extension, flange or machine feet.
Apply a coat of long-term anti-corrosion agent to all accessible bare parts.
protection.
SIMOTICS HV C 1NB1402-2AA84-4CA0-Z
Operating Instructions 06/2018