Table of Contents
Advertisement
CHAPTER 6 ERROR CODES
1 Generating Service Error Codes
When the Board is installed and bit 0 of service data #1 SSSW SW01 is set to '1', a ser-
vice error code will be indicated on the following reports if a communication ends in error:
communications control report, reception results report, and error transmission report. The
display will also indicate the following in response to an error:
System Monitor>Fax>Details
F06-101-01
6-1
COPYRIGHT © 2001 CANON INC.
2000 2000 2000 2000
CANON SUPER G3FAX BOARD-J1 REV.0 JUNE 2001
Advertisement
Table of Contents
Troubleshooting
