Canon Super G3 Fax Board-J1 Service Manual page 55

#1 SSSW-SW5: standard function (DIS signal) setting
Bit Function
0 not used
1 Conversion from mm to inch
(text mode)
2 Conversion from mm to inch
(text/photo mode)
3 send DIS signal bits 33 and over
4 Recording paper length availabilityA4/B4 size
declared in DIS signal
5 not used
6 not used
7 not used
[Bit 1]
Use it to enable/disable millimeter/inch conversion in sub scanning direction for images
read in text mode.
[Bit 2]
Use it to enable/disable millimeter/inch conversion in sub scanning direction for images
read in text/photo mode while bit 1 is set to '1'.
[Bit 3]
Use it to enable/disable transmission of bit 33 and thereafter (DIS signal).
If 'prohibit' is selected, the Super Fine reception function or Memory Box
function cannot be used for communications from non-Canon machines.
[Bit 4]
Use it to enable/disable declaration of the use of cut sheets (DIS signal).
For reception of an extra-long original, select 'A4/B4 size' if division is to be by the other
party.
Some machines are not designed to divide extra-long originals.
Memo
COPYRIGHT © 2001 CANON INC. 2000 2000 2000 2000
CHAPTER 5 SERVICE MODE
1 0
- -
convert do not convert
convert do not convert
prohibit do not prohibit 0
any size
- -
- -
- -
CANON SUPER G3FAX BOARD-J1 REV.0 JUNE 2001
Factory setting
0
0
0
0
0
0
0
5-13