Section 6-Troubleshooting - Invacare RPS350-1E User Manual

SECTION 6—TROUBLESHOOTING
SECTION 6—TROUBLESHOOTING
SYMPTOMS
Noisy or dry sound from pivots.
Electric actuator fails to lift when button is
pressed.
Unusual noise from actuator.
Lift arms will not lower from the uppermost
position.
NOTE: If problems are not remedied by the suggested means, please contact your dealer or Invacare.
Stand Assist Patient Lift
FAULTS
Needs lubrication.
Hand-control or actuator
connector loose.
Battery low.
RED emergency stop button
pressed IN.
Battery not connected properly
to control box.
The connecting terminals are
damaged.
Electric actuator in need of ser-
vice or load is too high.
Actuator is worn or damaged
or spindle is bent.
Lift arms require a minimum
weight load to lower from the
uppermost position.
20
SOLUTION
Refer to Lubricating the Lift on page 22.
Check the hand control and actuator con-
nections. Re-connect as necessary.
Charge batteries. Refer to Using the Battery
Charger to Charge the Battery on page 13.
Rotate RED emergency stop button
CLOCKWISE until it pops out.
Reconnect the battery to the control box.
Refer to Using the Battery Charger to
Charge the Battery on page 13.
Replace the battery pack. Refer to Using the
Battery Charger to Charge the Battery on
page 13.
Refer to Adjusting the Base on page 22.
Contact Dealer if service is required.
Replace the actuator or contact Dealer.
Refer to Replacing the Electric Actuator on
page 23.
Pull down slightly on the lift arms.
Part No. 1078985