Honeywell SLG 700 User Manual page 54

Probe Length 1.0m to 2.0m
Step
1
2
3
4
Probe Length ˃ 2.0m
Step
1
2
3
4
Page 42
Fully thread the nut onto the central conductor of the process connector. Place a
lock washer between the locknut and the first rod segment and torque the nut
against the rod segment and lock washer to secure the connection.
Note: Tighten rod connection point to the following torque:

SLG720 6.0Nm (4.4ft-lbs)
Connect the rod "end" segment to first using a stud and lock washer.
Note: Tighten rod connection point to the following torque:

SLG720 6.0Nm (4.4ft-lbs)
Place a "U-shaped" spacer onto the groove at the bottom of the rod "end"
segment.
Slip the coaxial outer tube over the rod and spacer and tighten to the process
connector.
Note: Tighten connection point to the following torque:

SLG720 30Nm (22ft-lbs)
It is recommended that a process compatible thread locking compound
(i.e. Loctite 242) be used on the outer conductor threaded joints.
Fully thread the nut onto the central conductor of the process connector. Place
a lock washer between the locknut and the first rod segment and torque the
nut against the rod segment and lock washer to secure the connection.
Note: Tighten rod connection point to the following torque:

SLG720 6.0Nm (4.4ft-lbs)
Connect the rod segment to the first using a stud and lock washer.
Note: Tighten rod connection point to the following torque:

SLG720 6.0Nm (4.4ft-lbs)
Place a "star shaped" spacer over the lock washer between the rod segments
as shown in Figure 3-8.
Slip the "starter" coaxial outer tube over the rod and spacers and secure to the
process connector using the M20x1 thread.
Note: Tighten connection point to the following torque:

SLG720 30Nm (22ft-lbs)

It is recommended that a process compatible thread locking compound
(i.e. Loctite 242) be used on the outer conductor threaded joints.
SLG 700 SmartLine Level Transmitter User's Manual
Action
Action
Revision 7