If necessary, unplug the interface connector from the Communication module. Do
4.
not discard the connector.
Note:
does not display the 8 pin interface connector. The interface connector
connects the Display module to the Communication module. If this is not in
place the display will not receive power.
Set each jumper to the desired position (UP/OFF or DOWN/ON).
5.
See Table 4-10 and Table
If applicable, re-install the Display module as follows:
6.
•
•
•
Note:
Orient the Display for proper viewing through the end cap window. You can rotate
the mounting orientation in 90
Restore transmitter power if removed.
Page 108
The example diagram Figure 5-2: Electronic Housing
4-11.
Orient the display as required.
Install the Interface Connector in the Display module such that it will mate
with the socket for the display in the Communication module.
Carefully line up the display, and snap it into place. Verify that the two tabs
on the sides of the display latch.
Installing a Display Module into a powered transmitter may cause a
temporary upset to the loop output value.
°
increments.
SLG 700 SmartLine Level Transmitter User's Manual
Components
Revision 7