Honeywell SLG 700 User Manual page 114

Measurd Prod Lvl (R)
Surface Sgnl Str (R)
Interfc Sgnl Str (R)
Device Vars
Surface Sgnl Qlty (R)
Interfc Sgnl Qlty (R)
(two liquids only)
Int Elec Temp (R)
(two liquids only)
Display Info
Firmware Version
(R) Read-Only parameter
<Return>
Firmware Version
Protocol (R)
Universal Rev (R)
(HART only)
Field Dev Rev (R)
(HART only)
Comm Info
Software Rev (R)
(HART only)
PV Alarm Type (R)
(HART only)
LRV (R) (FF only)
URV (R) (FF only)
<Return>
Firmware Version
Sensor Info
Model Key
Device ID
Page 102
Non-linearized
product level
Surface
Signal Strength
Interface
Signal Strength
For 2 liquid cases
Surface
Signal Quality
Interface
Signal Quality
For 2 liquid cases
Internal
Electronics
Temperature
#
HART/FF
N/A
HIGH
LOW
N/A
N/A
N/A
SLG 700 SmartLine Level Transmitter User's Manual
<Return>
If linearization is disabled then Product
Level and Measurd Prod Lvl will be same.
Signal strength depends on a function of
distance and the medium. As the level and
interface peaks are negative, a more
negative value indicates a better signal.
Signal strength improves as distance
Normal range: (-500) – (-9000)
Quality measurements range:
Less than 0.3 = Bad
Internal temperature measurement of the
<Return>
# Firmware version of display module
Firmware version of communications module
Communications protocol of transmitter
Applicable only for HART device
Revision of Hart specification
Applicable only for HART device.
HART HCF hardware revision
For DD/DTM compatibility
Applicable only for Hart device
Hart HCF software revision
Applicable only for HART device
Loop current behavior during critical fault.
HIGH : 21.5mA
LOW : 3.5mA
Displays the analog output will be scaled to 4mA.
Displays the measuring value for which the analog
output will be scaled to 20mA.
Firmware version of sensor module
Type and range of transmitter
Unique for each device considered as serial number
HART only.
decreases.
0 – 1
0.6 -- 0.8 = Good
1 = Perfect
sensing module.
Revision 7