Install Conduit Entry Plugs And Adapters; Table 3-19: Conduit Entry Plug Installation; Table 3-20: Conduit Adapter Installation - Honeywell SLG 700 User Manual

3.2.13 Install conduit entry plugs and adapters

THE CONDUIT/CABLE GLAND ENTRIES OF THIS PRODUCT ARE SUPPLIED
WITH PLASTIC DUST CAPS WHICH ARE NOT TO BE USED IN SERVICE.
IT IS THE USER'S RESPONSIBILITY TO REPLACE THE DUST CAPS WITH
CABLE GLANDS, ADAPTORS AND/OR BLANKING PLUGS WHICH ARE
SUITABLE FOR THE ENVIRONMENT INTO WHICH THIS PRODUCT WILL BE
INSTALLED. THIS INCLUDES ENSURING COMPLIANCE WITH HAZARDOUS
LOCATION REQUIREMENTS AND REQUIREMENTS OF OTHER GOVERNING
AUTHORITIES AS APPLICABLE
Install the Transmitters in accordance with national and local code requirements.
Conduit entry plugs and adapters must be suitable for the environment, and be certified
for the hazardous location when required and acceptable to the authority having
jurisdiction for the plant.
Step
Remove the protective plastic cap from the threaded conduit entry.
1
To ensure the environmental ingress protection rating on tapered
2
(NPT), a non-hardening thread sealant may be used.
Thread the appropriate size conduit plug (M20 or ½" NPT) into the
3 conduit entry opening. Do not install conduit entry plugs in conduit
entry openings if adapters or reducers will be used.
4 Using a 10mm hex wrench, tighten plugs to 32Nm (24lb-ft).
Step
1
2
3
4
Page 74

Table 3-19: Conduit entry plug installation

Table 3-20: Conduit adapter installation

Remove the protective plastic cap from the threaded conduit entry.
To ensure the environmental ingress rating on tapered threads
(NPT), a non-hardening thread sealant may be used.
Thread the appropriate size adapter (M20 or ½ NPT) into the
conduit entry opening
Using a 1-1/4" wrench tighten adapters to torque 32Nm (24lb-ft).
SLG 700 SmartLine Level Transmitter User's Manual
Action
Action
Revision 7