Procedures - Honeywell SLG 700 User Manual

5.4.7 Procedures

Step – 1: Determine the wire type of the wire probe, multi-twist or single twist:
Step – 2: Determine the sensor firmware version of the transmitter (the procedure will vary
depending on the user interface. Consult the User's Manual, the HART Manual, or the FF
Manual.
a) 1.000000/1.000100: a change of probe type to multi-twist wire is not supported. The
transmitter must first be upgraded to a more recent release then the instructions
applicable to that release will apply.
b) 1.010000: a change of probe type to multi-twist wire is supported. Either a HART or
FF user interface is required to make the appropriate settings change.
c) 1.020000: a change of probe type to multi-twist wire is supported with all interfaces.
Revision 7
Multi-twist
SLG 700 SmartLine Level Transmitter User's Manual
Single-twist
Page 127