ESP Enterview VX User Manual page 10

Enterview VX Manual_Layout 2 01/08/2013 09:22 Page 10
Press the # key to delete the code from the location, a 2 second confirmation
tone will be heard.
Return to the beginning to delete more codes or press the * key to exit
programming mode.
Deleting user codes from an unknown location
Enter programming mode.
Press the # key
Enter the 4 digit user code to search and delete, a 2 second confirmation tone
will be heard.
Press the * key to exit programming mode.
Deleting all settings
This function should only be used in extreme circumstance as all user codes will be
deleted.
Enter programming mode.
Press the # key once.
Press the # key a further eight times to delete all information the LED will turn
off and a tone will be heard to indicate that the delete process is taking place.
You must enter all
9#s to complete the delete all command.
Note: this does restore factory settings of the lock release time of 5 seconds.
Setting the lock time
Factory default door open time is set at 05 seconds.
Enter programming mode.
Enter 00 (this selects the unlock time location).
Enter the desired lock/relay operation time in a two digit format (01 to 99
seconds).
The keypad will return to the programming mode base level.
Press the * key to exit programming mode.
Changing the programming code
Factory default pin 1234.
Power down the outdoor station.
Press and hold the star key.
Keep pressing the star key and power back up
A continuous tone will be heard for 5 seconds .
Release the star key wait for 5 seconds .
Enter your new 4 digit programming code you should hear the acceptance bleep
and the indication light will go out.
10