Installation Procedure - Rinnai 800 Operation & Installation Manual

INSTALLATION PROCEDURE

Installation Continued
• Ensure the power supply to the appliance is isolated.
WARNING
j. Slide the appliance into the decorative surround,
whilst routing the flexible gas hose through the
supply access opening at the rear on the left hand
side as shown. Ensure no components are
damaged during this process. Use the two levelling
screws fastened by locknuts in the base at the front
of the appliance to level and stabilise the
appliance.
k. When the appliance is stable and level fasten it
against the decorative surround using the two
holes on each front flange (four holes in total).
l. Attach the flue pipe to the appliance flue spigot in
accordance with the Flueing Installation
Instructions.
m. Attach the flexible gas supply hose from the
appliance to the ½" BSP socket connection on the
gas supply pipe.
A gas leak test must be carried out in accordance with AS 5601. Use a soapy
solution on all gas connections. Leaks will be visible when the soapy solution
NOTE
forms bubbles. When finished wipe the soapy solution off with a rag.
7. Fit the two stainless steel side reflectors
the right and left reflector brackets on the burner tray
support with the top angle section facing upwards as
shown.
8. To re assemble carry out the above in the reverse
order.
Rinnai Australia
Fastening
holes
by placing
6
6
Left
Reflector
- 17 - Constellation Model 800/1000 - Installation Manual
6
Right
Reflector