Steps For Installation - Rinnai 800 Operation & Installation Manual

INSTALLATION PROCEDURE

STEPS FOR INSTALLATION

1. Determine the preferred location of the Constellation Flame Fire. Check roof space for any flue
obstructions.
2. Construct the decorative surround in accordance with the Framing Dimensions.
3. Install the flue in accordance with the Instructions supplied with the flue terminal taking note of the
following:
a. Flue termination above the roof must comply with AS 5601.
b. Vertical flue height must be no less than 3.6 metres.
c. The vertical height from the appliance to the first 45 degree bend must be at least 1.2 metres.
d. A maximum of 2 x 45 degree bends may be used.
e. The inner and outer flue pipes must be supported independently of the flame fire and the flue
installation guide in accordance with AS 5601.
4. Run the gas supply. For pipe sizing, use a gas pipe sizing chart such as the one in AS 5601.
The gas supply pipe should be run leaving a ½" BSP socket connection at the position shown on
Framing Dimensions.
5. Purge the gas supply of air and debris. All foreign materials such as filings must be purged from the
gas supply as they may cause the gas control valves to malfunction.
6. Prepare and install the appliance as follows:
(Refer Diagram 1).
a. Place the appliance on a flat surface.
b. Remove the two screws from the bottom
horizontal edge of the appliance surround
Lift the appliance surround to disengage
from the two clips on the top horizontal edge.
c. Pull appliance surround
appliance.
d. Remove the four screws holding the front
panel assembly
e. Disconnect the Communication Cable from
the rear of the remote control sensor
f. Remove the two screws holding the Flue
Cover Assembly
flue cover assembly to provide access for
flue attachment.
g. Remove the flexible gas hose and reducing
flare from the packaging carton. Ensure that
the hose, flare and gas supply pipe are free
of damage and debris. Attach flexible gas
hose pipe and reducing flare to the BSP
connection of the gas regulator assembly.
(Refer Diagram 2).
h. Slide the appliance into the decorative
surround, whilst routing the flexible gas hose
through the supply access opening at the
rear on the left hand side as shown. Ensure
no components are damaged during this
process. Use the two levelling screws
fastened by locknuts in the base at the front
of the appliance to level and stabilise the appliance.
i. Connect appliance to the electrical supply.
This applies only if the appliance is direct wired.
Rinnai Australia
away from
1
in place.
2
3
in place. Remove the
4
4
6
.
1
.
5
305
P
138
P (1 : 4)
1/2"BSPT MALE UNION
- 16 - Constellation Model 800/1000 - Installation Manual
2
3
6
NOTE:
5
DECORATIVE FASCIA ONLY
COMES WITH CONSTELLATION
BLACK MODEL
DIAGRAM 1
1
Q
Q (1 : 4)
DIAGRAM 2