Replacement Parts; Troubleshooting Chart - Standard Horizon HX600S User Manual

The inherent quality of the solid-state components in STANDARD HORIZON radios will
provide many years of continuous use. Take the following precautions to prevent damage
to the radio.
Keep the microphone connected or the jack covered at all times to prevent corrosion of
electrical contacts;
Never key the transmitter unless an antenna or suitable dummy load is connected to
the antenna receptacle.
Ensure that the input voltage does not exceed the value specified in your Owner's
Manual.
Use only STANDARD HORIZON-approved accessories and replacement parts.

14.2 REPLACEMENT PARTS

Occasionally an owner needs a replacement parts. These can be ordered from our Parts
Department by writing or calling:
Marine Division of Vertex Standard
US Headquarters
10900 Walker Street, Cypress, CA 90630, U.S.A.
Telephone (714) 827-7600
Commonly requested parts, and their part numbers are listed below.
・VOLUME Knob: xxxxxxxxx
・CD-26 Charger Cradle: xxxxxxxxx
・MIC/SP Cover: xxxxxxxxx
・DISTRESS Cover: xxxxxxxxx

14.3 TROUBLESHOOTING CHART

SYMPTOM
The [SCAN] key does not
start the scan.
The USA/INTL/CAN modes
do not function.
Cannot change any function.
TROUBLESHOOTING CHART
PROBABLE CAUSE
No channels memorized.
Squelch is not adjusted.
Proper operation
followed.
Key Lock is on.
27/39
FCC ID: K6630193X20
IC ID: 511B-30193X20
Operating Manual
REMEDY
Use the MEM key to enter
desired channels into the
transceiver's memory.
Adjust the
threshold or to the point
where noise just disappears.
Further adjustment of the
squelch control
eliminate incoming signals.
not HOLD down the 16/9 key
and press the WX key.
Turn Key Lock off. Refer to
section 5, 5 LAMP key.
Vertex Standard Co., Ltd.
squelch to
may