Know What The Presser Feet Will Do; Check The Presser Foot; Change The Presser Foot; Instmcciones Del Estilo De Ojales - Kenmore 385.1883 Owner's Manual

Know What the Presser Feet Will Do
• Check the Presser Foot
The presser feet are an important feature ot this machine. You need to know
what each foot does in order to use them effectively.
Your presser toot is held in place by a toot holder. Each presser toot merely
snaps on the toot holder, which is seldom removed.
If you need to remove or attach the toot holder, here is what you do:
To Remove:
J
To Remove:
Turn the screw toward the back ol
the machine. Use the large screw
driver.
To Attach:
,f
_ J
To Attach:
1. Match the hole in the toot holder
with the threaded hole in the
presser bar.
2. Fit the toot holder screw into the
hole.
3. Tighten the screw by turning it
toward you.
14
• Change the Presser Foot
Use the correct presser toot tot the stitch you wish to sew. Consult the Stitch
Pattern Chart and the detailed directions for sewing with the various presser
feet.
To Snap Off:
f
To Snap Off the Presser Foot:
1. Raise the needle bar to its highest
position by turning the hand wheel
toward you.
2. Raise the presser loot.
3. Press the snap-on button on the
back of the toot holder.
The presser loot will drop off.
Snap-on !
bulton
To Snap On:
f-- To Snap On the Presser Foot:
1. Place the presser toot so the hod-
zontal pin on the toot lles just under
the groove of the toot hotder.
2. Lower the presser foot holder to lock
the presser loot in place.
NOTE: If you do not hear the presser
toot snap in place, press
down on the presser toot
holder firmly until you hear
the snap.