Fcc-Approved Antennas (2.4 Ghz) - Digi XBee3-PRO Hardware Reference Manual

Regulatory information

FCC-approved antennas (2.4 GHz)

The XBee3 RF Module can be installed using antennas and cables constructed with non-standard
connectors (RPSMA, RPTNC, etc.) An adapter cable may be necessary to attach the XBee connector to
the antenna connector.
The modules are FCC approved for fixed base station and mobile applications for the channels
indicated in the tables below. If the antenna is mounted at least 25 cm (10 in) from nearby persons,
the application is considered a mobile application. Antennas not listed in the table must be tested to
comply with FCC Section 15.203 (Unique Antenna Connectors) and Section 15.247 (Emissions).
The antennas in the tables below have been approved for use with this module. Cable loss is required
when using gain antennas as shown in the tables.
Digi does not carry all of these antenna variants. Contact Digi Sales for available antennas.
XBee3™ RF Module Hardware Reference Manual
United States (FCC)
29