Declarations Of Conformity; Antennas; Ic (Industry Canada); Labeling Requirements - Digi XBee3-PRO Hardware Reference Manual

If the CE marking is reduced or enlarged, the proportions given in the above graduated drawing must be respected.
n
The CE marking must have a height of at least 5 mm except where this is not possible on account of the nature of the apparatus.
n
The CE marking must be affixed visibly, legibly, and indelibly.
n
Digi customers assume full responsibility for learning and meeting the required guidelines for each country in their distribution market. Refer to the radio
regulatory agency in the desired countries of operation for more information.

Declarations of conformity

Digi has issued Declarations of Conformity for the XBee3 RF Modules concerning emissions, EMC, and safety. For more information, see
www.digi.com/resources/certifications.

Antennas

The following antennas have been tested and approved for use with the XBee3 RF Module:
All antenna part numbers followed by an asterisk (*) are not available from Digi. Consult with an antenna manufacturer for an equivalent option.
Dipole (2.1 dBi, Omni-directional, Articulated RPSMA, Digi part number A24-HABSM)
n
PCB antenna (surface mount boards only) (0.0 dBi)
n
Chip antenna (micro form factor only) (0.0 dBi)
n

IC (Industry Canada)

Labeling requirements

Labeling requirements for Industry Canada are similar to those of the FCC. A clearly visible label on the outside of the final product enclosure must display
the following text.

For XBee3:

Contains Model XBEE3, IC: 1846A-XBEE3
The integrator is responsible for its product to comply with IC ICES-003 & FCC Part 15, Sub. B -Unintentional Radiators. ICES-003 is the same as FCC Part
15 Sub. B and Industry Canada accepts FCC test report or CISPR 22 test report for compliance with ICES-003.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.