Table of Contents
Advertisement
4. Installation
Wiring the Power Outputs
Please follow the steps below to insert the power wires.
Step 1: Please find one terminal block connector within two DC power
outputs shown below:
The wire gauge for the terminal block should be in the range of
12 ~ 24 AWG.
Step 2: Insert the Negative/Positive DC wires into the V– / V+ terminal;
Terminals 1 and 3 for Power 1; Terminals 2 and 4 for Power 2.
Step 3: Connect the other end of DC power wires to the power devices.
Tighten the wire-clamp screws for preventing the wires from
loosening.
1 V-
2 V-
3 V+
4 V+
Power Output
V+
V+
12V
19V
24V
DC Voltage
Power Output
V+
V+
12V
19V
24V
DC Voltage
Powered
Device 1
Maximum Output 70 Watts
Powered
Device
1
Total Maximum
Output 70 Watts
Powered
Device
2
11
Advertisement
Table of Contents
