Fault Codes - Taylor-Dunn C0-425-48 Operator's Manual

Maintenance Monitor
Note: The Maintenance Monitor function is optional. The
Maintenance Monitor function can be turned ON or OFF
by your dealer.
Operation: The SVD notifies the operator 10-hours (standard)
before a scheduled maintenance is due. During this warning
period, the meter will continue to alert the operator. This should
allow sufficient time for the operator to schedule the maintenance that is due, with minimal down
time. If the scheduled maintenance is not performed before the warning period elapses, then
the vehicle's maximum speed will be significantly reduced.
Warning period: The warning starts when the Maintenance Indicator is ON and the Wrench icon
is flashing. The Wrench icon will continue to flash until the warning time has expired.
Maintenance Due: Once the warning has expired and the maintenance is due, the Wrench
icon will stop flashing and remain ON. Additionally, the vehicle's
maximum speed will be significantly reduced until the maintenance
is performed and the display is reset. The display should only be
reset by an authorized technician. Refer to the Illustrated parts
section for information regarding tools required to reset the Smart
View Display.

Fault Codes

Level 1 Faults
Code Description
F01000 P/S Motor Overheated
F01001 Motor Brush Fault
F01002 Pump Motor Brush Fault
F01003 P/S motor Brush Fault
F01004 Low Battery Volts
F01005 Controller Overheated
F01006 Traction Motor Hot
F01007 Pump Motor Overheated
F01008 Wiring fault
Level 2 Faults
Code Description
F02000 Throttle Fault
F02001 Throttle Fault
F02002 Belly Switch Fault
F02003 Open Field
F02004 Open Field L
F02005 Open Field R
Page 22
What to do
Stop the vehicle and allow the system to cool down.
Refer to service technician
Refer to service technician
Refer to service technician
Batteries are empty and require charging. If this fault does not reset
after the charge cycle is complete then there may be a problem with
the charger or batteries. Refer to qualified service technician.
Stop the vehicle and allow the system to cool. This could be a result of
an overloaded vehicle.
Stop the vehicle and allow the system to cool down. This could be a
result of an overloaded vehicle
Stop the vehicle and allow the system to cool down.
Refer to service technician
What to do
Occurs if throttle control voltage is high at start up indicating that the
throttle pedal was pressed when the start switch was closed. If the
pedal was not pressed, then refer to qualified service technician.
Throttle module FS-1 switch is closed (pedal pressed) or wiring
shorted when start switch is turned on. Throttle module output high
when start switch is turned on.
Refer to service technician
Refer to service technician
Refer to service technician
Refer to service technician
Huskey C-425 Sevcon DC System Operator Manual
MC-425-12