Optional Log Media Installation; Log Placement - Pacific energy MIRAGE 18 Installation And Operating Instructions Manual

The Driftwood log-set with pebbles requires that any crushed glass media be removed if it is present. The
pebbles are spread out around the perimeter of the burner basket after which the glowing embers are evenly
spread out inside of the burner basket - (Figure 33). The stove is delivered with two media dividers - a large
one for the Mirage 30 model (Figure 31), and a smaller one for the Mirage 18 model. The divider will be
placed into the center of the burner basket (Figure 32) and is used to separate the pebbles and glowing
embers.

Log Placement

1. Position rear log #1 at the back of the rebox on
top of the pilot sheild. (Figure 33)
2. Interlock right log #2 with rear log use the pin in
the burner tray to position the log (Figure 34) .
Figure 31: Media divider.
Note: Keep gap in media
divider (Figure 31) faced to the
rear of the burner basket, next
to the pilot assembly.
Note: It is not necessary to use the entire contents of the Embers bag and the Rocks
bag. Use enough to cover the burner tray with a single layer. Any more can interfere
with proper flame distribution.
Figure 34: Log 2.
060718-44

Optional Log Media Installation

Note: Do Not Block Pilot With Logs
Log Pin
Figure 32: Media divider in place.
Figure 35: Log 3.
3. Lean left log 3 against log set engage the pins
in log #1 and the burner tray (Figure 35).
4. Interlock front log #4 with left log and use
the pin in the burner tray to position the log
(Figure 36).
Embers
Rocks
27
Figure 33: Log 1.
Figure 36: Log 4.
100000432-50