Operating Instructions - Pacific energy MIRAGE 18 Installation And Operating Instructions Manual

A balanced flue free standing gas heater
Table of Contents

Advertisement

Warning: The home owner must not make any adjustments to the appliance
other than what can be achieved by using the remote handset (Figure 1) and
the settings control / battery holder located at the bottom of the surround
backing plate (Figure 20). Any other adjustments must be performed by a
qualified service technician.
Before operating this appliance, proceed through the following checklist.
1. Read and understand these instructions before operating this appliance.
2. Check to see that all wiring is correct and enclosed to prevent possible shock.
3. Check to ensure that there are no gas leaks.
4. Make sure that the glass door is in place. Never operate the appliance with the glass door
removed.
5. Verify that all ueing and the termination cap is unobstructed.
6. Verify log placement.
7. When lighting the appliance, the inside of the glass may fog up. This will burn off after a few
minutes of operation.
NOTE: After 3 failed
attempts to ignite, the
fireplace will enter a
1 minute hibernation
period before attempting
to ignite again.
060718-44

Operating Instructions

7
NOTE: Fireplace may take
up to 30 seconds to ignite
each time the "ON" button
has been selected.
100000432-50

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents