Continuous Pilot/Intermittent Pilot (Cpi/Ipi) Selection; Key Lock; Low Battery Power Detection; Receiver - Pacific energy MIRAGE 18 Installation And Operating Instructions Manual

Continuous Pilot/Intermittent Pilot (CPI/IPI)
selection
With the system in the "OFF" position, press the
Mode Key (Figure 1) to index to the CPI mode
icon (Figure 12). Pressing the Up Arrow Key will
activate the Continuous Pilot Ignition mode (CPI).
Pressing the Down Arrow Key will return to IPI.
A single "beep" will con rm the reception of the
command.
Figure 12: IPI - CPI control.

Key Lock

This function will lock the keys to avoid unsupervised operation. To activate this
function, press the MODE and UP keys at the same time (Figure 1).The lock icon
will appear (Figure 13). To deactivate this function, press the MODE and UP key at
the same time.

Low Battery Power Detection

Transmitter
The life span of the remote control batteries depends on various factors: quality of
the batteries used, the number of ignitions of the Stove, the number of changes to
the room thermostat set point, etc.
Figure 13: Key lock.
When the remote control transmitters' batteries are low, an icon will appear on the
LCD display (Figure 14) of the remote before all battery power is lost. When the
batteries are replaced this icon will disappear.

Receiver

The life span of the IFC module batteries depend on various factors: quality of
the batteries used, the number of ignitions of the Stove, the number of changes
to the room thermostat set point, etc.
When the IFC batteries are low, a "double-beep" will be emitted from the IFC
module when it receives a command from the remote. This is an alert for a low
battery condition for the IFC module. When the batteries are replaced, a single
Figure 14: Low battery.
"beep" will be emitted from the IFC module when a key is pressed - "Initializing
the Fireplace for the rst time" on page 10.
060718-44
13
100000432-50