Table of Contents
Advertisement
Remote Transmitter Description
The Pro ame2 Remote Control consists of two elements:
1. Pro ame2 Remote Control Transmitter.
2. Pro ame Integrated Fireplace Control (IFC Module) board and a wiring harness to connect the IFC to the
gas valve and stepper motor (Figure 43).
Transmitter (Remote Control with LCD Display)
The Pro ame 2 Transmitter uses a streamline design with a simple key layout and an informative LCD display
(Figure 2). The remote control transmitter is powered by 3 AAA batteries. A mode key is provided to index
between the features and a thermostat key is used to turn on/off or index through thermostat functions
(Figure 1)
.
IFC Module
The Pro ame2 Integrated Fireplace Control (IFC) module is a device that allows automatic ignition and pilot
ame supervision and commands the functions of the replace. It's con gured to control the ON/OFF main
burner operation, giving the choice of both IPI (intermittent pilot ignition), and CPI (continuous pilot ignition)
modes. The Pro ame 2 IFC module controls and connects directly to the pilot assembly and the automatic
valve using low electric power.
The IFC module can be powered by both an AC power supply, and battery pack for back up. The Pro ame
2 offers the added ability to control the comfort fan speed from OFF through six (6) speeds. The external
batteries can provide DC power to the IFC allowing the batteries to be used only when line power is
interrupted or lost.
Operating Procedure
Initializing the Fireplace for the rst time
1. With the gas stove power plug unplugged and the main switch - located in the rear of the stove, turned to
the OFF position, remove the switches' face plate and install 4 AA batteries into the battery holder (Figure
20). Once the batteries are installed and the switches' face plate reattached, turn the selection switch to
"Remote" setting.
2. Install 3 AAA batteries into the Pro ame 2 Remote Control Transmitter (Figure 3).
3. Plug the power plug in and turn on the gas supply.
4. Insert a straightened paper clip into the opening marked "PRG" of the switches' face plate Figure 20 and
press the program key once (alternately, if the face plate is already off, simply press the "PRG" button on
the battery holder). The IFC module, also located on the inside of the gas stove enclosure, will beep 3
times indicating that it is ready to synchronize with a remote control transmitter.
5. On the remote control transmitter, push the power on key once. The remote control transmitter will beep
4 times to indicate that the remote control transmitter and the IFC module are now synchronized. The
remote control transmitter is now ready to use.
100000432-50
10
060718-44
Hide quick links:
Advertisement
Table of Contents
