Burner Kit/Media Installation/Removal; Installation; Removal - Pacific energy MIRAGE 18 Installation And Operating Instructions Manual

Burner Kit/Media Installation/Removal

Burner Tray Installation / Removal

Installation

Interior panels must be installed before burner tray can be installed.
The injector must be removed prior to burner tray insertion (Figure
28). Remove 2 - 3/8" (9.525 mm) nuts and extract the injector from
the rebox.
Insert the burner tray (Figure 26) and insert 4 Robertson screws to
x it in place. Reinstall the injector and two 3/8" (9.525 mm) nuts.
Evenly spread a thin layer of crushed glass across the entire burner
pan (Figure 30).
Note: It is not necessary to use the entire bag of crushed
glass. Use enough to cover the burner tray with a single
layer. Any more can interfere with proper fl ame distribution.

Removal

Begin by removing the exterior side panel on your right hand side as
you face the Mirage 18 (Figure 47 on page 33).
Remove the injector from the side wall of the Mirage 18 (Figure 28).
Remove the glass media then remove the 4 screws (Figure 27) with a
screwdriver, and remove the burner tray (Figure 27).
060718-44
Nuts
Ori ce
Figure 28: Ori ce extraction.
Figure 26: Burner tray insertion and
removal.
Figure 27: Unfastening the burner tray.
Figure 29: Glass media in burner tray.jpg
25
Screws
100000432-50