Table of Contents
Advertisement
To access and remove the pilot assembly.
Figure 56: Empty rebox.
1. Turn off the Mirage and allow it to cool down before proceding.
2. At the rear of the Mirage, disconnect the power cord.
3. Shut the gas supply off at its source.
4. On the front side of the stove, remove the screen cover and glass door from the front of the Mirage. See
"Door Removal / Installation" on page 28.
5. Remove media from rebox.
6. Remove the burner tray by removing four screws and extracting the tray as shown in Figure 5747.
7. Remove interior panels as outlined in "Firebox Panel Removal / Installation" on page 24.
Pilot
head
Figure 58: Pilot head and securing clip.
8. Remove the pilot head by taking the securing clip off and lifting the head off of its support (Figure 58).
This will prevent damage while the the pilot control panel is being extracted through the rear of the unit.
9. Remove the two Philips screws securing the pilot head assembly to its support (Figure 59).
10. Remove all of the screws surrounding the support. These include screws on the oor in front of the
support and on the wall behind the support (Figure 59).
060718-44
Pilot Assembly Replacement
Securing
clip
Figure 57: Burner tray
Figure 59: Control panel front side screws.
35
removal.
100000432-50
Hide quick links:
Advertisement
Table of Contents
