Example - Edwards EPX HiVac Series Instruction Manual

A419-00-880 Issue F
4.8

Example

Here is an example of how to interpret the menu diagrams. The following procedure describes how to change the
parameters displayed on the normal display.
1. Press the Setup button to enter the Setup menu
2. Use the up and down buttons to change the first digit of the setup password to the correct value, then press the
ENTER button.
3. Use the up and down buttons to change the second digit of the setup password to the correct value, then press
the ENTER button.
4. Use the up and down buttons to change the third digit of the setup password to the correct value, then press the
ENTER button.
5. If you have entered the correct password, the display will then show 'SETUP MENU' on the top line and the
software version on the bottom line.
6. Press the down button or the up button twice; the display will then show 'SETUP MENU' on the top line and
Normal display on the bottom line.
7. Press the ENTER button; the display will then show 'SELECT LINE' on the top line and 'Top Page 1' on the bottom
line (refer to Figure 28).
8. Press the ENTER button; the display will then show 'SELECT PARAMETER' on the top line and the currently
selected parameter on the bottom line.
9. Press the up or down buttons to change the parameter displayed to the required parameter, then press the
ENTER button. The top line of the Normal Display will now display the parameter that was selected.
Page 40
(Figure 25).
(Figure 26).
Edwards and the Edwards logo are trademarks of Edwards Limited.
© Edwards Limited 2007. All rights reserved.