Connections; Control And Monitoring; Epx Pump Labels; End User Controller (Euc) Display - Edwards EPX HiVac Series Instruction Manual

A419-00-880 Issue F
1. Run button
2. Display
3. Down button
4. CANCEL button
5. Up button
1.5

Connections

Refer to Table 2 and Figure
1.6

Control and monitoring

The EPX L and N series of pumps cannot be manually operated; they must be controlled and monitored by external
control equipment, which must be connected to the EPX pump through the TIM
The EPX E series of pumps can be manually operated using the EUC local display and keypad, or remotely using a PDT,
if fitted; it can also be controlled and monitored over the network, which connects to the EPX pump through the
Network connector (Figure
monitors the status of the pump.
The EPX pump is compatible with Fabworks 32.
1.7

EPX pump labels

Refer to Table 3 and Figure
Page 12
Figure 7 - End User Controller (EUC) display
6. ENTER button
7. Menu buttons Status, Normal, Control, Setup
8. Menu selected LEDs
9. Status LEDs Local Control, Warning, Alarm
10. Stop button
4.
5, item 2). When the EPX 'E' series of pumps is controlled via the TIM, the EUC simply
4.
Edwards and the Edwards logo are trademarks of Edwards Limited.
(Figure 2, item 5).
© Edwards Limited 2007. All rights reserved.