Epx L Pump Labelling Information (Refer To Figure 4) - Edwards EPX HiVac Series Instruction Manual

Number Label Name
1 Pump details
2 Power
3 Run
4 Warning
5 Alarm
6 Warning - risk of electric
shock
7 Warning - risk of electric
shock
8 Status LED label
9 and 10 Lifting point
11 Warning - risk of high
temperature
12 Direction of rotation
13 Warning - danger of injury
from rotating parts
14 Water in
15 Protective earth stud
16 Pump interface
17 Warning - risk of electric
shock
18 Warning - risk of electric
shock
19 Warning - thermal shock
20 Water out
21 Product label
© Edwards Limited 2007. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Table 3 - EPX L pump labelling information (Refer to Figure 4)
Description
This provides specific information about the pump including: pump
type; code number; serial number; pump weight; year of
manufacture; and name and address of the manufacturer. It also
includes electrical supply requirements, and compliance marks.
The power LED. See
The run LED. See
The warning LED. See
The alarm LED. See
Do not remove cover until 4 minutes after disconnection of the
power.
Do not remove cover until 4 minutes after disconnection of the
power.
Status LED label.
The pump must be lifted using the eyebolts on the pump and
suitable lifting equipment.
Surface temperatures can exceed 65
Arrow shows the correct direction of rotation of the rotor.
Turn off and lock-out all power prior to servicing.
The cooling water supply pipeline connects to the pump at this
location.
This equipment must have a second protective earth. See
Section
Tool Interface Module (TIM) fits in this position. The pump may be
controlled through this. See
Do not remove cover until 4 minutes after disconnection of the
power.
Do not remove cover until 4 minutes after disconnection of the
power.
If the pump has overheated or the cooling water has failed,
connecting cooling water to a hot pump will cause severe damage to
the pump.
Always allow the pump to cool for at least 20 minutes before
connecting cooling water.
The cooling water return pipeline connects to the pump at this
location.
Product name.
Table 1 for details.
Table 1 for details.
Table 1 for details.
Table 1 for details.
3.10.
Section
A419-00-880 Issue F
o
C during pump operation.
3.11.
Page 9