Pnnnn" - Set User Position Memory Pointer; R" - Reset Memory Pointers; Reset" - Reboot The Lc-2 Microprocessor; S" - Display Status - Geokon LC-2x4 Instruction Manual

30

3.26 "Pnnnn" - Set User Position Memory Pointer

Type P and a number between 1 and 10666 to position the pointer. Arrays can then be displayed
(D command) from the new position. The updated pointers will display after entering a valid
position.
*P1
MS:3200
*

3.27 "R" - Reset Memory Pointers

Reset memory pointers to default settings. Gage and interval settings, as well as the real-time
clock settings, are not affected by this command. User will be asked to verify before executing.
Press Y to continue, any other key to abort.
*R
Are you sure(Y/N)?Y
Memory cleared.
*
Note: This command does not erase memory. If the need arises to recover data that was
previously taken, take one or more readings and then position the memory pointers via the P and
D commands to recover previously taken readings

3.28 "RESET" - Reboot the LC-2 Microprocessor

All stored readings and settings, as well as the ID and real-time clock settings are not affected by
this command.
*RESET
Resetting...
RESET COMPLETE
*
3.29 "S" – Display Status
Displays the datalogger Status.
*S
MS:1004
4 Channel Multiplexer Selected.
Scan interval: 15 second(s).
Logging stopped.
Log intervals disabled.
Monitor mode enabled.
*
OP:1567 UP:1
OP:1005 UP:1004