Nd" - Network Disable; Ne" - Network Enable; Ns" - Display Network Status - Geokon LC-2x4 Instruction Manual

<ENTER>
<ENTER>
#10<ENTER>
Network address: 10
*NA
Network address: 10
*E
NOTE: If connected directly to the datalogger via USB and networking is enabled, the
datalogger will respond with the * prompt only.
NOTE: The network address cannot be changed while networked. Direct connect to the
datalogger via USB in order to change the network address.

3.23 "ND" - Network Disable

Disables networking of two or more LC-2x4 dataloggers.
*ND
Network recognition disabled.

3.24 "NE" - Network Enable

Enables networking of two or more LC-2x4 dataloggers.
*NE
Network recognition enabled.
Note: If a networked LC-2x4 is connected via the RS-232 or USB port, connection to the
datalogger can be made directly without the need to enter the correct datalogger address. This
can be helpful if the network address is unknown and the datalogger is network enabled.

3.25 "NS" - Display Network Status

Displays the current network status.
*NS
Network recognition disabled.
*
Or;
*NS
Network recognition enabled.
*
29