Com Port Settings - Geokon LC-2x4 Instruction Manual

14
4) In the COM Properties window, configure the COM port (see Figure 15):
8002-4-1 (RS-232): Configure the COM port (typically COM1 or COM2) as 9600 Bits per
second, 8 Data bits, no Parity, 1 Stop bit, no Flow control.
8002-4-2 (USB): Configure the new COM port that is added when the LC-2x4 is connected as
9600 Bits per second, 8 Data bits, no Parity, 1 Stop bit, no Flow control.
5) Click Apply then OK.
6) Press <ENTER> <ENTER> to wake the datalogger from sleep. The datalogger returns the
power up prompt:
Hello. Press "?" for Help.
*
Note: If no characters are received in 15 seconds the datalogger (non-networked)
will return to its low power sleep mode. Press <ENTER> <ENTER> to wake it
again.
Note: When network commands are enabled and RS-485 is being used, the address
must be sent before the respective datalogger will respond. See Sections 3.21 thru
3.25 for additional information.
Figure 15 - COM Port Settings