Ld" - Disable Log Intervals; Le" - Enable Log Intervals; M" - Display Current Monitor Mode Setting; Md" - Disable Monitor Mode - Geokon LC-2x4 Instruction Manual

26

3.13 "LD" - Disable Log Intervals

If logging is started (ST command) it will continue based on the scan interval entry (SC
command).
*LD
Log intervals disabled.
*Datalogger#1,2007,11,25,11,41,17,2.92,20.63,9.055,
-999999.0,-999999.0,-999999.0,22.5,-99.0,-99.0,-99.0,549
*

3.14 "LE" - Enable Log Intervals

If logging is started (ST command) it will continue based on the interval lengths and iterations of
the log list (SC command).
*LE
Log intervals enabled.
*Datalogger#1,2007,11,25,11,42,56,2.92,21.51,9.042,
-999999.0,-999999.0,-999999.0,22.5,-99.0,-99.0,-99.0,622

3.15 "M" - Display Current Monitor Mode Setting

The monitor mode will display arrays as they are stored in memory in the course of logging. This
is useful where a test is being conducted and immediate display of logged values would be
helpful. Use the "MD" and "ME" commands (next two sections) to disable or enable the use of
the Monitor mode.
*M
Monitor mode enabled.
*

3.16 "MD" - Disable Monitor Mode

Arrays will not be sent to the host computer as they are logged.
*MD
Monitor mode disabled.
*

3.17 "ME" - Enable Monitor Mode

Arrays will be sent to the host computer as they are logged.
*ME
Monitor mode enabled.
*