10-Pin Bulkhead Models (8002-4A-1, 8002-4A-2, 8002-4A-3); Table 1 - Transducer Cablec - Geokon LC-2x4 Instruction Manual

Terminal
Block Position
VW1+
VW1-
TH1+
TH1-
SHLD1
VW2+
VW2-
TH2+
TH2-
SHLD2
VW3+
VW3-
TH3+
TH3-
SHLD3
VW4+
VW4-
TH4+
TH4-
SHLD4
5) Tighten the nuts on the cable fittings so that they securely grip the cables. This must
be done to ensure that water does not enter the enclosure. (Beware of
overtightening, which may damage the plastic threads.)

2.1.2 10-pin Bulkhead Models (8002-4A-1, 8002-4A-2, 8002-4A-3)

Transducers are attached to the datalogger with 10-pin Bulkhead connectors. Align the
grooves on the transducer connector (male), with the connector on the unit (female). Push
the connector into place and then twist the outer ring of the male connector until it locks.
Channel
Number
1 Vibrating Wire +
1 Vibrating Wire -
1 Thermistor +
1
Analog Ground
1
2 Vibrating Wire +
2 Vibrating Wire -
2 Thermistor +
2
Analog Ground
2
3 Vibrating Wire +
3 Vibrating Wire -
3 Thermistor +
3
Analog Ground
3
4 Vibrating Wire +
4 Vibrating Wire -
4 Thermistor +
4
Analog Ground
4
Table 1 - Transducer Cable Connections
Description
Thermistor -
(shield)
Thermistor -
(shield)
Thermistor -
(shield)
Thermistor -
(shield)
Cable
Wire
Color
RED
BLACK
WHITE
GREEN
BARE
WIRE
RED
BLACK
WHITE
GREEN
BARE
WIRE
RED
BLACK
WHITE
GREEN
BARE
WIRE
RED
BLACK
WHITE
GREEN
BARE
WIRE
3