Appendix H. Model 8032-27 And Load Cell Wiring; Figure 26 - Model 8032-27 J; Table 17 - Common Conductor; Table 18 - Multiplexer Board - Geokon LC-2x4 Instruction Manual

APPENDIX H. MODEL 8032-27 AND LOAD CELL WIRING

Connect the "common" VW- conductor from the load cell to the 8032-27 by lifting up on the orange tab
located on the opposite side of the six black conductors, inserting the common conductor fully into the
8032-27 (Figure 26), and then pushing down on the orange tab until it snaps into place. Refer to Table 17
to identify which conductor carries the common VW- signal.
10 pin Bendix
PT06A-12-10P Function
H Common
White's black and Green wires are switched on Geokon three-gage VW load cells prior to serial number 3313.
*
The following wiring chart details the connections between the load cell, the 8032-27, and the multiplexer board:
Figure 26 - Model 8032-27 Jumper Wire Assembly
3 Gage VW Load Cell,
Purple Cable
White's Black*
Table 17 - Common Conductor Chart
Multiplexer
Board
VW1+
VW1-
TH1+
TH1-
SHLD1
VW2+
VW2-
TH2+
TH2-
SHLD2
VW3+
VW3-
TH3+
TH3-
SHLD3
VW4+
VW4-
TH4+
TH4-
SHLD4
Table 18 - Multiplexer Board Wiring
4 Gage VW Load Cell,
Purple Cable
Green
Vibrating Wire
with Thermistor
VW Sensor #1
8032-27
Thermistor
Thermistor
Shield Drain Wire
VW Sensor #2
8032-27
-
-
-
VW Sensor #3
8032-27
-
-
-
VW Sensor #4
8032-7
-
-
-
6 Gage VW Load Cell,
Orange Cable
Blue
57