Temperature Zero Readings And Thermal Factors; Output Labels; Figure 15 - Set Temperature Zero And Thermal Factor; Figure 16 - Uncomment Specified Line - Geokon 8600-2 Instruction Manual

18
E.3.3 Temperature Zero Readings and Thermal Factors
N : T
OTE EMPERATURE
. T
CORRECTION
'
A GAUGE S READINGS DUE TO TEMPERATURE CHANGE
VARIES ON DIFFERENT MODELS OF GAUGES AND TEMPERATURE CORRECTION IS OFTEN NOT
. D
REQUIRED EPENDING ON THE GAUGE MODEL
;
AVAILABLE SOME GAUGE MODELS REQUIRE A DIFFERENT FORMULA TO COMPENSATE
T
EMPERATURE CORRECTION IS COMMENTED OUT IN THE MAIN PROGRAM FILE BY DEFAULT
Default values for Temperature Zero Readings and Thermal Factors are 0. Temperature
Zero Readings and Thermal Factors can be added if the user requires the Datalogger to
use temperature compensation.
Navigate to the Main (.CR6) file C:\Campbellsci\CRBasicEditor. Open the Main (.CR6)
file with notepad and uncomment the line specified in the code for all model gauges that
temperature correction is required.
E.3.4 Output Labels
Default Alias names correspond with the Direct or Multiplexer channel of each gauge and
are displayed in the Header of the Data file. Alias names can be modified by the user.
W : A
ARNINGS
MUST ONLY CONTAIN ALPHANUMERIC VALUES AND UNDERSCORES
). A
SYMBOLS LIAS NAMES
Z T
ERO AND HERMAL
EMPERATURE CORRECTION

Figure 15 - Set Temperature Zero and Thermal Factor

Figure 16 - Uncomment Specified Line

N
LIAS AMES CANNOT BE MORE THAN
M
UST BEGIN WITH AN ALPHA CHARACTER
F
ACTORS ARE USED FOR TEMPERATURE
CAN BE USED TO COMPENSATE FOR CHANGES IN
. T
EMPERATURE EFFECT ON READINGS
,
TEMPERATURE CORRECTION MAY NOT BE
35
CHARACTERS LONG AND
.
.
(N
O SPACES OR