Mxs" - Display Multiplexer Status; Mxn" - Set The Maximum Number Of Channels; N" - Display Next Measurement Cycle - Geokon LC-2x4 Instruction Manual

3.18 "MXS" – Display Multiplexer Status
Displays the Multiplexer Status.
*MXS
LC-2MUX 4-Channel Multiplexer Setup:
CH 1: ENABLED
GT: 3 ZR: 0.00000 GF: 1.00000 GO: 0.00000 TH: 0
CH 2: ENABLED
GT: 1 ZR: 0.00000 GF: 1.00000 GO: 0.00000 TH: 0
CH 3: ENABLED
GT: 1 ZR: 0.00000 GF: 1.00000 GO: 0.00000 TH: 0
CH 4: ENABLED
GT: 1 ZR: 0.00000 GF: 1.00000 GO: 0.00000 TH: 0
*
3.19 "MXn" – Set the Maximum Number of Channels
Set the maximum number of channels of the multiplexer. Can be set to 4 or 16. Set to 4 by the
factory for all LC-2x4 dataloggers.
*MX4
4 Channel Multiplexer Selected.
*

3.20 "N" - Display Next Measurement Cycle

Displays the next time the datalogger will initiate a measurement cycle. If the start time (ST
command) has been set, this command will display when logging will begin.
*ST12:00
Logging will start at: 12:00:00
*N
Next time to read: 12:00:00
*
27