Procedures; Soft Reset; Hard Reset; Change Channel - Geokon 8800 Troubleshooting Tips

2

3. PROCEDURES

3.1 Soft Reset

 Hold down the status button on the device for 10 seconds, until red and green LEDs turn on,
then release.

3.2 Hard Reset

1) Remove batteries
2) Press the status button and ensure no LEDs light up
3) Replace batteries

3.3 Change Channel

 Change switch setting when batteries are out of unit.
-Or-
 Change switch setting and then reset node.

3.4 Starting a Network

1) Set channel select switches to desired channel.
2) Power up the supervisor.
3) Power up a node in close proximity.
4) The network is established if within 20-30 seconds one of the following occurs:
• Red light activates every 10 seconds on the supervisor.
• Green light activates every 10 seconds on the node.
• Both sets of lights flash at the same time.
5) Start GeoNet Agent software.
6) Create a new network.
7) Enter address of supervisor.
8) Press "get network settings".
9) Communication with the supervisor is good if the serial number of the supervisor appears in
Serial Number textbox.
10) Press "set network time", current time will appear in textbox.