Audio Outputs - Axia iQx AES67 Installation & User Manual

Audio Configuration

Audio Outputs

The outputs page is accessed via the Outputs link under IO Manager. The page provides 32 outputs that can each be defined to
the facility needs. The default setting is for unused outputs to be reserved for Auto Backfeed. When a source is loaded that calls
for a backfeed, one of the outputs from the pool of Auto Backfeed will be assigned (and configured) as the backfeed. The profile
would need to be unloaded to reclaim the output. If no pool is available, the channel with the calling profile will show an error
condition on the display. Other options for the Output column are the audio content generated by the DSP.
Program 1, Program 2, Program 3, and Program 4 are the four standard output mixes.
♦
Record is a special mix driven by the P4 button (phone handset icon) and is a mix which is Pre-ON and Post-Fader.
♦
Phone is another special mix driven by the P4 button and is a Pre-ON and Pre-Fader mix.
♦
CR Monitor is the control room monitor driven by the monitor section of the console.
♦
CR Monitor Direct is a pre-volume-knob source, which is not impacted by mute states and follows the CR Monitor
♦
selection.
CR Headphone is the operator headphone feed and is driven by the console's Headphone section of the Monitor
♦
section.
Preview is the preview mix (cue mix) driven by channels that are applied to Preview.
♦
Talk to CR is audio content of any profile that initiates a talkback to the Control Room. This is mixed in with the
♦
Preview mix for the operator to hear the audio, but if there is an application for only the talkback audio, this is the
source to utilize.
Chapter 3 |
30