Axia iQx AES67 Installation & User Manual page 34

Audio Configuration
Preview Mode
Permits choosing whether Preview acts in CUE (pre-fader) or SOLO (post-fader) mode.
Preview Switching
Check all options that apply to the prefered workflow.
Channel ON turns Preview OFF
♦
Preview ON turns Channel OFF
♦
Auto-Start Timer
When selected, the count-up timer will start when the channel is turned ON and the counter is set to Auto (Show Profile
setting).
Logic Port
Option to disable GPIO machine logic to source device or enable it in two modes. Exclusive mode permits GPIO control
associated with only a single fader. Shared mode allows more than one user to send ON/OFF/START signals to the source via
GPIO. Some profile types support an optional "GPIO Ready mode" and there would be a check box to enable this option. This
allows devices such as CD players or tape machines to signal their READY state to the operator through the OFF button LED.
If a device is cueing, its OFF lamp will not be lit. Linking the device's OFF lamp to the Ready command means that a machine
must be cued and ready before the OFF lamp illuminates. If enabled, the OFF lamp illuminates when the fader is OFF and the
Ready command is active on the GPIO. If disabled, the OFF lamp illuminates normally whenever the fader is turned OFF. Refer
to GPIO section for more specifics on GPIO for each source type.
GPIO Hybrid Control (Phone Type)
Define the method of control to the phone interface.
Soft-Key Only (default) uses only the software button (soft button) next to the Preview button to control the state of
♦
the interface (on hook / off hook).
Channel ON Answers Hybrid - GPIO control of a phone interface would be triggered when the ON state is changed.
♦
Channel ON or Preview Answers hybrid - GPIO control of a phone interface would be changed based on ON state or
♦
Preview state of the channel .
Refer to GPIO section for more specifics on GPIO call outs for source profiles.
Feed to Source (Phone, Codec, Microphone, and Studio Feed Type)
The backfeed (mix-minus) for a source is automatically generated, but this field defines the content of said backfeed. As an
example, a phone mix-minus would be the content of Program 1 minus the phone, so this field would be set to Program 1 and
the workflow would be achieved. The options available are:
Disabled - no backfeed.
♦
Auto (Pgm-1/Phone) feeds the Program 1 mix (minus the source) when this source's fader is ON, and feeds the
♦
"Phone" mix (minus the source) when the fader is OFF. Remember, the Phone mix is a special variant of Program 4.
The Phone mix is pre-fader and pre-on/off to allow speaker-phone style operation through the Operator's mic.
Program 1 always feeds the Program 1 mix, minus the source, regardless of the on/off state of the channel.
♦
Program 2 feeds the Program 2 mix, minus the source.
♦
Program 3 feeds the Program 3 mix, minus the source.
♦
Program 4 feeds the Program 4 mix, minus the source.
♦
Phone feeds the Phone mix, minus the source. Phone is a pre-fader and pre-on/off variation of Program 4
♦
Talk Only is a "silent backfeed" that operates when the Talk To function is engaged, creating an IFB to the source.
♦
Chapter 3 |
24