Split Recording Of Telephone Calls - Axia iQx AES67 Installation & User Manual

Tear Sheets - Specific Use Case Configurations

Split recording of telephone calls

A common practice is to record phone conversation in a two track recording, giving access to post edit the caller or host audio. Within a
Source profile is the Signal mode for Record bus property. For each profile we define the routing to the record mix.
1. Select the Sources link.
2. Select the Source profile for the operator microphone. Edit the profile.
3. Find the Signal mode for Record bus property and select 'Sum to Left'.
4. Hit the OK button.
5. Select the Source profile for the phone interface. Edit the profile.
6. Again, find the Signal mode for Record bus property and select 'Sum to Right'.
7. Hit the OK button.
8. Make sure the Record output is one of the assigned outputs and that this network stream is routed to the recording
device.
9. Assign the operator microphone and phone interface to fader channels on the console. If already loaded, make sure to
reload them so the new setting in their profiles take place.
10. The operator and phone faders should both be applied to P4 (Program 4 assignment button, which has a Phone
handset icon).
11. Keep the channels in the off position and move the faders to the unity gain position.
12. You should have recording levels from the operator microphone and the caller with gain adjustment by moving
the faders.
Appendix B |
62